Steering Wheel
WARNING
Never adjust the steering wheel while the vehicle is moving: Adjusting the steering wheel while the vehicle is moving is dangerous.
Moving it can very easily cause the driver to abruptly turn to the left or right. This can lead to loss of control or an accident.
Steering Wheel Adjustment
To change the angle or length of the steering wheel: 1. Stop the vehicle, and then pull down the lock release lever under the steering column.

2. Tilt the steering wheel and/or adjust the steering column length to the desired positions, and then push the lever up to lock the column.
3. Attempt to push the steering wheel up and down to make sure it's locked before driving.
Fuel-Filler Lid and Cap
MirrorsTie Rod Inspection
1. Inspect for bending and damage.
If there is any malfunction, replace the tie rod.
2. Inspect for excessive play.
If there is any malfunction, replace the tie rod.
3. Swing the tie rod five times.
4. Measure the swing torque of the tie rod using a pull scale.
...
Sail Garnish Removal/Installation
1. Open the front door.
2. Affix protective tape to the position shown in the figure.
3. Insert a tape-wrapped flathead screwdriver into the shown in the figure and
remove the clip A in the direction of arrow (1).
4. Pull the sail garnish in the direction of the arrow (2) and remove it w ...
Down Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The down switch detects the shift down operation of the selector lever.
The down switch signal is sent to the TCM via CAN and is used for manual
shift control and engine-transaxle integration control.
Construction
The down switch is installed to the se ...