Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Steering Gear And Linkage Removal/Installation

Mazda CX-5 Service & Repair Manual / Steering / Linkage, Power / Steering Gear And Linkage Removal/Installation

CAUTION:

1. Remove the joint cover..

2. Disconnect the intermediate shaft from the steering gear and linkage..

3. Disconnect the front ABS wheel-speed sensor wiring harness installed to the steering knuckle and set it aside..

4. Remove the front under cover No.2..

5. Remove the front under cover No.1..

6. Remove the splash shield..

7. Remove the front crossmember component..

8. Remove in the order indicated in the table.

9. Install in the reverse order of removal.

10. After installation, inspect the front wheel alignment..



1

Steering gear and linkage installation bolt

2

Steering gear and linkage

(See Steering Gear and Linkage Removal Note.)


Steering Gear and Linkage Removal Note

1. Remove the steering gear and linkage installation bolts, move the steering gear and linkage in the direction and order of the arrows shown in the figure, and then remove it.


Steering Gear And Linkage Inspection
1. Remove the steering gear and linkage.. 2. Remove the tie-rod end and boot.. 3. Measure the rotation torque of the pinion shaft using a crescent wrench and pull scale. (speed measurement refer ...

Wheel, Column
...

Other materials:

Wheel Hub Component Removal/Installation [Awd]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (body side) ...

Vanity Mirror Illumination Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move a flathead screwdriver in the direction of the arrow (1) shown in the figure and detach the lens tab and sunvisor. 4. Detach a ...

DSC HU/CM Removal/Installation
WARNING: If the DSC HU/CM configuration is not completed, it could result in an unexpected accident due to the DSC being inoperative. If the DSC HU/CM is replaced, always use the automatic configuration function so that the DSC operation conditions are correct. If the DSC re ...

© 2016-2025 Copyright www.mcx5.org