Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Steering Gear And Linkage Assembly

Mazda CX-5 Service & Repair Manual / Steering / Linkage, Power / Steering Gear And Linkage Assembly

CAUTION:

1. Assemble in the order shown in the figure.



1

Steering gear

2

Mounting rubber

(See Mounting Rubber Assembly Note.)

3

Tie rod

(See Tie Rod Assembly Note .)

4

Boot

5

Boot band

(See Boot Band Assembly Note .)

6

Boot clamp

7

Locknut

8

Tie-rod end

(See Tie-rod End Assembly Note.)

9

O-ring

10

Dust cover


Mounting Rubber Assembly Note

1. Apply soapy water to the rubber part of the mounting rubber.

2. Press fit the ear portion of the mounting rubber (lower side) using the SSTs until it projects from the gear housing as shown in the figure.


NOTE:

3. Reverse the gear housing, then press fit the mounting rubber using the SSTs and the press until the mounting rubber ear portion (upper side) contacts the gear housing.


4. Verify that both mounting rubber ears are correctly assembled with no gaps between them and the gear housing as shown in the figure.


Tie Rod Assembly Note

1. Lock the steering rack end (pinion gear side) against rotation with a wrench and install the tie rod using the suitable wrench.


2. Combine the the SST

with the torque wrench, then measure A and L as shown in the figure.


3. Recalculate the torque by using torque formulas, then tighten the tie rod using the SST

.


CAUTION:

Torque formula


Torque unit

Formula

NВ·m

NВ·mГ—[L/A]

kgfВ·m

kgfВ·mГ—[L/A]

ftВ·lbf

ftВ·lbfГ—[L/A]


Boot Band Assembly Note

1. Assemble the boot band to the boot.

2. Crimp the boot band using the SST

.


3. Verify that the crimping clearance A is within the specification.

4. Rotate the by hand and verify that it is securely installed to the boot band.

Tie-rod End Assembly Note

1. Align the alignment marks made before removal and assemble the tie-rod end to the tie rod.


2. Adjust dimension A shown in the figure to the standard, then assemble the tie-rod end.


Steering Gear And Linkage
Purpose/ Function The rotational movement input from the intermediate shaft is converted to a linear movement in the horizontal direction of the steering rack by the rack and pinion mecha ...

Steering Gear And Linkage Disassembly
CAUTION: To prevent damage to the steering gear, secure it to the vise using a copper plate or clean cloth. 1. Disassemble in the order indicated in the figure. 1 ...

Other materials:

High Pressure Fuel Pump Inspection
NOTE: The following vacuum values are indicated by relative pressure from the fuel pressure sensor. 1. Verify that the fuel pressure sensor is normal.. 2. Connect the M-MDS to the DLC-2. 3. Switch the ignition ON (engine off). 4. Select the “FUEL_PRES”, “LOAD” and “R ...

Disc Pad (Rear) Replacement
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, pump the brake pedal a few times and inspect the following: The disc pad projection is securely installed to the piston groove Parking brake lever stroke Bra ...

Brakes
Abbreviations AAS Active Adaptive Shift ABS Antilock Brake System ABDC After Bottom Dead Center ACC Accessories AFS Adaptive Front Lighting System ...

© 2016-2024 Copyright www.mcx5.org