Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Steering Angle Sensor Inspection

1. Remove the column cover..

2. Connect the plus (+) end of a tester to steering angle sensor terminal A and the minus (-) end of the tester to terminal B (GND).


3. Switch the ignition ON (engine off or on).

4. Turn the steering wheel to the left and right.

5. Verify that the voltage from steering angle sensor terminal A to B (GND) is as indicated in the table.


6. Switch the ignition to off.

7. Connect the plus (+) end of a tester to steering angle sensor terminal C and the minus (-) end of the tester to terminal B (GND).


8. Switch the ignition ON (engine off or on).

9. Turn the steering wheel to the left and right.

10. Verify that the voltage from steering angle sensor terminal C to B (GND) is as indicated in the table.


Steering Angle Sensor
Purpose, Function The steering angle sensor outputs the steering angle and steering angle reference point during the period which the EPS control module performs initial learning (approx. ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the ...

Other materials:

Steering Switch Inspection
Without Bluetooth system WARNING: Handling the driver-side air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings and cautions before handling the air bag module.. 1. Switch the ignition OFF (LOCK ...

Fuel Pump Control
Outline By switching the fuel pump discharge amount, reduced power consumption and improved fuel economy have been realized. The PCM determines the optimum fuel pump drive force according to the engine operation conditions, and sends the fuel pump drive signal to the fuel pump ...

Quarter Window Glass Removal
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. e. D-pillar trim. f. C-pillar trim. 3. Apply protective tape along the edge of the body and the quarter window glass. WARNING: ...

© 2016-2022 Copyright www.mcx5.org