Purpose, Function
The steering angle sensor outputs the steering angle and steering angle reference point during the period which the EPS control module performs initial learning (approx. 1 min period).
Construction
The steering angle sensor is installed to the clock spring.
Consists of the gear which rotates together with the steering (magnet) and the magnetic sensor.
Operation
By the rotation of the gear (magnet) corresponding to the steering operation, the magnetic sensor output value changes.
The steering angle sensor outputs the magnetic sensor output to the start stop unit.
Fail-safe
Function not equipped.
Rear Power Window Regulator Removal/Installation
1. Fully lower the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Rear door trim.
b. Rear door quarter glass.
c. Rear door speaker.
d. Rear power window motor.
e. Rear door glass.
4. Remove bolts.
5. Insert a hand through the speak ...
PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “RCM”.
3. Select the applicable PID from the PID table.
4. Verify the PID da ...
Rear Drive Shaft Disassembly/Assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
1
Boot band (differential side)
(See Boot Band (Differential Side) Disassembly Note.)
(See Boot Band (Differential Side) Assembly Note.)
2
...