Mazda CX-5 Service & Repair Manual: Starting, Charging

Rear Body Control Module (Rbcm) Removal/Installation

CAUTION: If configuration is not performed when the rear body control module (RBCM) is replaced with a new one, the vehicle specification information is not stored in the rear body contr ...

Charging System Warning Light [Skyactiv G 2.0]

Purpose, Function Warns the driver of a charging system malfunction. Construction The charging system warning light is built into the instrument cluster.. Operation ...

Other materials:

Upper Cowl Side Reinforcement Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 13 locations indicated by (A) shown in the figure. 2. Drill the 8 locations indicated by (B) shown in the figure. NOTE: When a drill the 8 locations indicated by (B) shown in the figure, the through hole is not made in consideration of ...

Front Body Control Module (Fbcm) Configuration (Using Read/Write Function)
NOTE: When performing configuration, it is necessary to read the vehicle specification information from the front body control module (FBCM) before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the front body control module (FBCM). ...

Blind Spot Monitoring (Bsm) Control Module Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Connect the negative battery cable.. 5. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference). If the voltage is n ...