Mazda CX-5 Service & Repair Manual: Starter Disassembly/Assembly [Skyactiv G 2.0]
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
|
1 |
Magnetic switch |
|
2 |
Adjustment washer |
|
3 |
Rear housing |
|
4 |
Brush and brush holder |
|
5 |
Armature |
|
6 |
Yoke |
|
7 |
Planetary gear |
|
8 |
Front cover |
|
9 |
Lever |
|
10 |
Drive pinion |
|
11 |
Internal gear |
|
12 |
Gear shaft |
Starter Cut Off Control [Skyactiv G 2.0]
Outline
The PCM controls energization to the starter relay according to an immobilizer
system request to improve security.
While not in P or N position, the starter relay energizatio ...
Starter Inspection [Skyactiv G 2.0]
On-vehicle Inspection
1. Verify that the battery is fully charged.
2. The starter is normal if it rotates smoothly and without any noise when the
engine is cranked.
If the starter does no ...
Other materials:
Differential Oil Temperature Sensor Inspection
WARNING:
Hot differential oil may cause severe burns. Do not perform maintenance while
differential oil is hot.
1. Disconnect the negative battery cable.
2. Disconnect the differential oil temperature sensor connector and remove the
differential oil temperature sensor.
3. Wrap ...
Tie Rod End Replacement
1. Remove the snap pin.
2. Loosen the tie-rod end locknut.
3. Detach the tie-rod end from the steering knuckle using the SST.
4. Remove the tie-rod end locknut.
5. Place alignment marks as shown in the figure for proper installation.
6. Remove the tie-rod end.
7. Align th ...
Solar Radiation Sensor [Full Auto Air Conditioner]
Purpose
The solar radiation sensor detects the sunlight intensity emitted to the
cabin.
Function
The solar radiation sensor converts the detected solar radiation amount to
an electric signal.
Construction
A photodiode (light receiving diode) has been adopted fo ...
