CAUTION:
If configuration is not performed when the start stop unit is replaced with a new one, the vehicle specification information is not stored in the start stop unit and the system will not operate normally.
When performing configuration, it is necessary to read the vehicle specification information from the start stop unit before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the start stop unit. The vehicle specification information is temporarily stored in the M-MDS.
NOTE:
The start stop unit prior to replacement stores the vehicle specification information.
A new start stop unit does not store any vehicle specification information.
If the vehicle specification information from the start stop unit prior to replacement cannot be read, perform the configuration using As-Built data.
1. When replacing the start stop unit, perform the configuration..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Driver-side air bag module.
b. Steering wheel.
c. Clock spring.
d. Column cover.
e. Wiper and washer switch.
f. Light switch.
4. Disconnect the connector.
5. While pressing the tabs of the clip in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach the connector tabs from the start stop unit.
6. Remove the wiring harness clip from the start stop unit.
7. Make a groove on the bolt head by punching it with a chisel using a hammer, and remove the bolts by rotating them counterclockwise.
8. Remove the bolts.
9. Remove the start stop unit from the steering shaft by pulling it in the direction of the arrow shown in the figure.
10. Install in the reverse order of removal..
NOTE:
If configuration cannot be performed by reading/writing of the vehicle specification information, perform the configuration using As-Built information after replacing the start stop unit..
Start Stop Unit Installation Note
1. Temporarily install the start stop unit to the steering shaft using new start stop unit installation bolts.
2. Tighten the start stop unit installation bolts until the heads break off.
Turn and Lane-Change Signals
NOTE
• If an indicator light stays on without
flashing or if it flashes abnormally, one of the turn signal bulbs may be burned
out.
• A personalized function is available to change
the turn indicator sound volume.
Refer to Personalization Features on .
Turn Signals
Move the signal lev ...
Air Filter
Purpose
The air filter removes pollen and dust in the intake air and purifies air
flowing into the cabin.
Function
The air filter removes pollen and dust using a dust collecting filter.
Construction
The air filter is installed to the blower unit.
It ...
Front Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the front
scuff plate in the direction of the arrow (1) shown in the figure, then detach the
hook B, clip C, and pin D while pulling in the direction of the arrow (2).
2. Take the shaded area shown in the figure, detach ta ...