Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Start Stop Unit

Purpose

Function

Control Table


Control

Content

Reference

Advanced keyless entry system control

Authorization of the remote transmitter being carried is automatically performed using radio waves, and all the doors lock/unlock according to the switch operation.

(See ADVANCED KEYLESS ENTRY SYSTEM.)

Keyless entry system control

When the lock/unlock buttons on the transmitter are pressed at a distance away from the vehicle, all the doors lock/unlock.

(See KEYLESS ENTRY SYSTEM.)

Push start system control

When the push button start is pressed, authorization of the remote transmitter brought into the vehicle is automatically performed.

(See PUSH BUTTON START SYSTEM [ADVANCED KEYLESS ENTRY SYSTEM].)

(See PUSH BUTTON START SYSTEM [KEYLESS ENTRY SYSTEM].)

Immobilizer system control

The immobilizer system is a vehicle theft prevention device that only allows a remote transmitter that has been previously programmed to the vehicle to start the engine.

(See IMMOBILIZER SYSTEM.)

On-board diagnostic system control

The start stop unit is equipped with an on-board diagnosis function which records DTCs in the event of a malfunction.

(See ON-BOARD DIAGNOSIS SYSTEM [ADVANCED KEYLESS ENTRY SYSTEM].)

(See ON-BOARD DIAGNOSIS SYSTEM [IMMOBILIZER SYSTEM].)

(See ON-BOARD DIAGNOSIS SYSTEM [START STOP UNIT].)

CAN (Controller Area Network)

Sends and receives signals between CAN system-related modules using CAN system.

(See CONTROLLER AREA NETWORK (CAN) SYSTEM.)


Structural view


System wiring diagram




Fail-safe

Keyless entry system

Advanced keyless entry system

Push button start system

Immobilizer system

Side Air Bag Sensor [Standard Deployment Control System]
Purpose The side air bag sensor detects an impact during a lateral collision. Function The side air bag sensor converts the detected impact to an electrical signal. Construct ...

Start Stop Unit Configuration (Using As Built Data)
NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the ...

Other materials:

Windshield Wiper Motor Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Windshield wiper arm and blade. b. Cowl grille. Windshield Wiper Motor Inspection 1. Apply battery positive voltage and connect the ground to the windshield wiper motor terminals as indicated in the table below a ...

Keyless Warning Alarm
Purpose The keyless warning alarm notifies the driver that the remote transmitter cannot be verified or the steering lock cannot be released. Function When the instrument cluster receives the keyless warning alarm request signal sent from the start stop unit via the CAN sig ...

Steering Column And Shaft
Purpose/Function The steering input force, generated when the driver operates the steering wheel, is transmitted to the steering gear. Construction The steering column and shaft consists of the steering column with a built-in EPS mechanism and the intermediate shaft. ...

© 2016-2024 Copyright www.mcx5.org