Mazda CX-5 Service & Repair Manual: Speaker [Without Bose®]
Purpose
-
Converts the audio signal from the audio unit to sound.
Function
-
Full-range speakers, which can output wide-range sound from low to high frequency, have been adopted.
Specification
|
Item |
Front door speaker |
Rear speaker |
Tweeter |
|
|
Rated input |
(W) |
10 |
10 |
10 |
|
Max. input |
(W) |
25 |
25 |
25 |
|
Rated impedance |
(ohm) |
3.4 — 4.6 |
3.4 — 4.6 |
3.4 — 4.6 |
|
Size |
(mm {in}) |
165 {6.5} (229 {9}) |
165 {6.5} |
80 {3.1} |
Construction
4 speaker type
-
A cone-shaped dynamic speaker has been adopted for each speaker.
-
Pulp for the cone material and a neodymium magnet have been adopted.
6 speaker type
-
A cone-shaped dynamic speaker has been adopted for each speaker.
-
Front door speaker/rear door speaker
-
Pulp for the cone material and a neodymium magnet have been adopted.
-
Tweeter
-
Polyethylene naphthalene for the cone material and a strontium ferrite magnet have been adopted.
Operation
-
The speaker sends the audio signal (current) from the audio unit to the voice coil.
-
When the audio signal (current) is sent to the voice coil, the coil becomes magnetized and a magnetic field occurs. Because the voice coil and the magnet pull and repel each other in the magnetic field, the voice coil vibrates.
-
Because the voice coil is wrapped around the voice coil bobbin, the voice coil bobbin vibrates when the voice coil vibrates.
-
When the voice coil bobbin vibrates, the cone (diaphragm) installed to the voice coil bobbin vibrates and generates sound.
Fail-safe
-
Function not equipped.
Speaker [With Bose®]
Purpose
Converts the audio signal from the audio unit to sound.
High quality sound is provided for the driver and passengers.
Function
Full-range speakers, which can output ...
Supplier Identification Procedure [Audio]
NOTE:
The unit supplier can vary. When asking the supplier (service center) for
repair or replacement, identify the supplier and fill in the Audio Repair Order
Form using the following p ...
Other materials:
Rear Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the rear
scuff plate in the direction of the arrow (1) shown in the figure, then detach hook
B, clips C, pins D while pulling in the direction of the arrow (2).
2. Take the shaded area shown in the figure, detach tab E whi ...
Fuel Tank Pressure Sensor
Purpose/Function
The fuel tank pressure sensor detects the fuel tank pressure.
Fuel tank pressure sensor is only used for OBD.
Construction
The fuel tank pressure sensor is equipped to the charcoal canister.
A piezoelectric-type sensor has been adopted.
...
Start Stop Unit
Purpose
Performs control of several systems based on input/output signals from switches.
Function
The start stop unit controls systems based on the input/output signals.
The functions which are controlled are as follows:
Control Table
Control ...
