Mazda CX-5 Service & Repair Manual: Speaker [With Bose®]
Purpose
-
Converts the audio signal from the audio unit to sound.
-
High quality sound is provided for the driver and passengers.
Function
-
Full-range speakers, which can output wide-range sound from low to high frequency, have been adopted.
-
A better sound effect and clear sound have been realized by using tweeters (speaker for upper register sound range) which differ the range of the output sound and woofer (speaker for lower register sound range).
Specification
|
Item |
Front door speaker |
Rear speaker |
Tweeter |
Front center speaker |
D-pillar speaker |
|
|
Rated impedance |
(ohm) |
1.25 |
3.7 |
3.24 — 3.96 |
3.24 — 3.96 |
3.24 — 3.96 |
|
Size |
(mm {in}) |
225 {8.86} |
133 {5.25} |
80 {3.1} |
80 {3.1} |
80 {3.1} |
Construction
-
A cone-shaped dynamic speaker has been adopted for each speaker.
-
Pulp for the cone material and a neodymium magnet have been adopted.
-
A better sound effect is achieved by the use of speakers which differ the range of the output sound.
-
Front door speaker (speaker for deep bass sound range)
-
Rear door speaker (speaker for all sound ranges)
-
Tweeter (speaker for medium-to-high-sound range)
-
Front center speaker (speaker for medium-to-high-sound range)
-
D-pillar speaker (speaker for medium-to-high-sound range)
Operation
-
For the speaker operation, refer to the SPEAKER [WITHOUT Bose®].
Fail-safe
-
Function not equipped.
Speaker Grille Removal/Installation
Center Speaker Grille
1. Insert a tape-wrapped flathead screwdriver into shown in the figure and remove
hooks A in the direction of arrow (1).
2. Take the shaded area shown in the figure, and ...
Speaker [Without Bose®]
Purpose
Converts the audio signal from the audio unit to sound.
Function
Full-range speakers, which can output wide-range sound from low to high frequency,
have been adopted.
...
Other materials:
Fuel Distributor
Purpose, Function
Distributes fuel pumped from the high pressure fuel pump to each fuel injector.
Construction
The fuel distributor is installed to the cylinder head.
The fuel distributor is integrated with the fuel pressure sensor.
...
Air Intake Actuator [Manual Air Conditioner]
Purpose
The air intake actuator moves the air intake door in the blower unit to switch
the air intake port.
Function
The air intake actuator drives the motor based on the signal from the climate
control unit and moves the air intake door to the FRESH or REC position.
...
Power Outer Mirror Inspection
Mirror Glass Adjustment
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
3. Apply battery positive voltage and connect the ground to the power outer mirror
terminals and inspect the power outer mirror ...
