Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Slide Motor Inspection

Mazda CX-5 Service & Repair Manual / Body / Seats / Slide Motor Inspection

WARNING:

CAUTION:

NOTE:

1. Disconnect the negative battery cable and wait for 1 min

..

2. Disconnect the slide motor connector.

3. Apply battery positive voltage to the slide motor terminals and inspect the front seat operation.



Front seat operation

Connection

B

D

Forward

GND

B+

Backward

B+

GND


Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]
CAUTION: When the seat weight sensor is replaced with a new one, perform the seat weight sensor calibration using the M?MDS.. When replacing the seat weight sensor, replace it t ...

Slide Motor Removal/Installation
WARNING: Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual befor ...

Other materials:

Rear Body Straight Line Dimensions (1) [Dimensions]
Point symbol Designation Hole diameter or bolt or nut size mm {in} A Liftgate hinge installation hole ?12 {0.47} B Liftgate stay damper installation hole ?10 {0.39} ...

Clock Spring Adjustment [Standard Deployment Control System]
1. Set the front wheels straight ahead. CAUTION: The clock spring will break if over?wound. Do not forcibly turn the clock spring. 2. Turn the clock spring clockwise until it stops. 3. Turn the clock spring counterclockwise approx. 2 turns. 4. Align the mark on the clo ...

Liftgate Garnish Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate recess. d. Liftgate lower trim. 3. Disconnect the connectors. 4. Remove nuts A. 5. Detach clips B shown in the figure. 6. Remove the liftgate ...

© 2016-2024 Copyright www.mcx5.org