Mazda CX-5 Service & Repair Manual: Sirius Satellite Radio Unit
Purpose
-
Satellite radio programming can be listened to.
Function
-
The voltage signal sent from the center roof antenna (SIRIUS satellite radio antenna) is output to the audio unit.
Construction
-
The SIRIUS satellite radio unit is installed to the interior of the glove compartment.
-
Consists of a bracket for securing to the dashboard member, and a tuner.
Terminal layout and signal
|
Terminal |
Signal |
|
|
|
A |
Power ground |
|
B |
— |
|
|
C |
Output RH (+) |
|
|
D |
— |
|
|
E |
Output LH (+) |
|
|
F |
— |
|
|
G |
Signal ground |
|
|
H |
— |
|
|
I |
— |
|
|
J |
— |
|
|
K |
CAN_L |
|
|
L |
CAN_H |
|
|
M |
— |
|
|
N |
— |
|
|
O |
ACC |
|
|
P |
B+ |
|
Operation
1. The SIRIUS satellite radio unit detects the radio station selected by the user from the electric signal sent from center roof antenna (SIRIUS satellite radio antenna).
2. The detected radio broadcast audio signal and the video signal are sent to the audio unit.
3. The audio unit outputs the audio and video signals received from the SIRIUS satellite radio unit.
Fail-safe
-
Function not equipped.
Rear Mount Camera Removal/Installation
CAUTION:
The audio unit communicates with the rear mount camera and records the presence/non-presence
of the rear mount camera when the ignition is switched to ACC or ON (engine
off or o ...
Sirius Satellite Radio Unit Removal/Installation
CAUTION:
The audio unit communicates with the SIRIUS satellite radio unit and records
the presence/non-presence of the SIRIUS satellite radio unit when the ignition
is switched to ACC or ...
Other materials:
Transaxle Fluid Temperature (Tft) Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The transaxle fluid temperature (TFT) sensor detects the ATF temperature
in the oil pan.
The transaxle fluid temperature (TFT) sensor signal is used for automatic
shift control, TCC control, line pressure control, direct electric shift control,
learning contr ...
Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and suspend it out of the way using a
cable.
2. Remove the disc plate.
3. Remove the wheel hub bolt using the SST as shown in the figure.
4. Place a new wheel hub bolt in the wheel hub.
5. Install the wheel hub by placing a proper sized washer o ...
Rear Drive Shaft Inspection
1. Inspect each connecting part for looseness.
Tighten or replace parts if necessary.
2. Inspect the dust boot on the drive shaft for cracks, damage, leaking grease,
and looseness in the boot band.
3. Inspect the drive shaft for bends, cracks, and wear in the joints or splines. ...
