Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Side Turn Light

Purpose

Function

Construction


Operation

Turn system

1. When the turn switch is operated to the RH position, a turn RH signal is input to the start stop unit.

2. When the turn switch is operated to the LH position, a turn LH signal is input to the start stop unit.

3. The start stop unit sends the turn RH or LH signal to the front body control module (FBCM).

4. When the front body control module (FBCM) receives the turn RH signal, the side turn light (RH) flashes.

5. When the front body control module (FBCM) receives the turn LH signal, the side turn light (LH) flashes.


Hazard system

1. When the hazard switch is turned on, a hazard signal is input to the start stop unit.

2. The start stop unit sends a hazard signal to the front body control module (FBCM).

3. When the front body control module (FBCM) receives the hazard signal, the side turn lights (RH) and (LH) flash.


Fail-safe

Rear Turn Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the di ...

Side Turn Light Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Outer mirror glass. b. Upper outer mirror garnish. c. Side turn light. 3. Apply battery voltage to side turn ligh ...

Other materials:

Accessory Socket
Purpose By inserting the plug of an electrical device, 12 V (maximum 120 W) of power is supplied enabling use of the electrical device in the vehicle. Function Front accessory socket When the ignition is switched to ACC or ON (engine off or on), 12 V (maximum 120 W) of pow ...

Liftgate Upper Trim Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the liftgate upper trim in the direction of the arrow (1) shown in the figure, then detach clips B, clip C and pin D while pulling in the direction of the arrow (2). 2. Take the shaded area shown in the figure, detach ...

Airflow Mode Actuator Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Dashboard under cover. b. Glove compartment. 3. Disconnect the airflow mode actuator connector. 4. Remove the screw. 5. Remove the airflow mode actuator. 6. Remove the airflow mode main link. 7. Remo ...

© 2016-2022 Copyright www.mcx5.org