1. Set the rear over fender aside..
2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove the clip A in the direction of arrow (1).
3. Slide the side step molding in the direction of the arrow (2) shown in the figure and remove clips B from side step molding.
4. After removing the side step molding, remove clip A, clips B from the body using a fastener remover.
5. Install clip A, clips B to the side step molding.
6. Install in the reverse order of removal.
Rear Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the rear
scuff plate in the direction of the arrow (1) shown in the figure, then detach hook
B, clips C, pins D while pulling in the direction of the arrow (2).
2. Take the shaded area shown in the figure, detach tab E whi ...
Engine Oil Solenoid Valve Removal/Installation
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous.
It can slip or fall, causing death or serious injury. Never work ...
Instrument Cluster Inspection
Speedometer inspection
Using a speedometer tester
1. Adjust the tire pressure to the specification.
2. Using a speedometer tester, verify that the tester reading is as indicated
in the following table. km/h
Speedometer tester indication (km/h)
Allowable rang ...