Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Side Air Bag Sensor Removal/Installation [Two Step Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Side Air Bag Sensor Removal/Installation [Two Step Deployment Control System]

WARNING:

1. Switch the ignition to off.

2. Disconnect the negative battery cable and wait for 1 min or more

..

3. Remove the following parts:

a. Remove the trunk board..

b. Remove the trunk end trim..

c. Remove the rear scuff plate..

d. Remove the trunk side trim..

4. Remove the bolt.


5. Disconnect the connector..

6. Remove the side air bag sensor.

7. Install in the reverse order of removal.

8. Switch the ignition ON (engine off or on).

9. Verify that the air bag system warning light illuminates for approx. 6 s

and goes out.

Connector Disconnect Note

1. Press the area (1) indicated by the arrow and slide it as shown in the figure (2).


2. Lift up the location shown in the figure using a tape-wrapped flathead screwdriver (3) and disconnect the connector (4).

Side Air Bag Sensor No. 1 Removal/Installation [Standard Deployment Control System]
WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and ca ...

Side Air Bag Sensor [Standard Deployment Control System]
Purpose The side air bag sensor detects an impact during a lateral collision. Function The side air bag sensor converts the detected impact to an electrical signal. Construct ...

Other materials:

Torque Converter [Fw6 A EL, Fw6 Ax EL]
Purpose/Function By use of an optimized torus shape (wing) matching the output characteristics of the engine, the torque converter achieves efficient force transmission and reduced fuel consumption. Construction/Operation A three-member, single-stage two-phase type torque c ...

Rear Oil Seal Replacement
1. Remove the transaxle.. 2. Remove the flywheel (MTX) or the drive plate (ATX).. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 Rear oil seal (See Rear Oil Seal Removal Note.) (See Rear Oil Seal Installation Not ...

Airflow Mode Control [Full Auto Air Conditioner]
Purpose The airflow mode control changes the airflow mode according to the vehicle environment. Function The airflow mode control drives the airflow mode actuator according to the mode switch, defroster switch, and the vehicle environment and switches the position of the ...

© 2016-2022 Copyright www.mcx5.org