Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Side Air Bag Module Removal/Installation [Standard Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Side Air Bag Module Removal/Installation [Standard Deployment Control System]

WARNING:

1. Switch the ignition to off.

2. Disconnect the negative battery cable and wait for 1 min or more

..

3. Remove the front seat..

4. Remove the seat back trim and the seat back pad..

5. Disconnect the side air bag module connector.


6. Remove the fastener.


7. Remove the nuts.


8. Remove the side air bag module.

9. Install in the reverse order of removal.

10. Switch the ignition ON (engine off or on).

11. Verify that the air bag system warning light illuminates for approx. 6 s

and goes out.

Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]
CAUTION: When the seat weight sensor is replaced with a new one, perform the seat weight sensor calibration using the M?MDS.. When replacing the seat weight sensor, replace it t ...

Side Air Bag Module [Standard Deployment Control System]
Purpose When a side air bag module receives an impact from a lateral collision, the operation (deployment) of the air bag mediates the impact to the chest, stomach, and waist of the drive ...

Other materials:

Airflow Volume Control [Full Auto Air Conditioner]
Purpose The airflow volume control changes the airflow volume according to the vehicle environment. Function The airflow volume control changes the operation of the blower motor according to the operations of the airflow volume control dial or temperature control dial an ...

Audio Amplifier Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (RH). b. Front side trim (RH). 3. Remove the bolts. 4. Lift up the audio amplifier in the direction of the arrow (1) shown in the figure, pull it in the direction of the arrow (2) shown in ...

Airflow Mode Actuator Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Dashboard under cover. b. Glove compartment. 3. Disconnect the airflow mode actuator connector. 4. Remove the screw. 5. Remove the airflow mode actuator. 6. Remove the airflow mode main link. 7. Remo ...

© 2016-2022 Copyright www.mcx5.org