CAUTION:
Since the servicing is performed with the hood open, secure the hood using a piece of wood to prevent it from falling.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Seal board upper.
b. Front bumper.
c. Front combination light.
d. Shroud upper member.
e. Set plate.
f. Energy-absorbing form.
g. Front under cover No.1.
h. Bumper stiffener lower.
3. Support the shroud panel using a jack.
CAUTION:
Because the shroud panel is installed to the bumper reinforcement, support the shroud panel using a jack before removing the bumper reinforcement so as not to apply excessive force to the shroud panel.
4. Remove the following parts:
a. Front bumper reinforcement.
b. Seal plate.
c. Hood latch.
d. Crash zone sensor.
e. Ambient temperature sensor.
f. Horn.
g. Air cleaner cover.
5. Remove clips A.
6. Remove the hood stay from the shroud panel, wrap the hood stay with protective tape, and install it as shown in the figure to support the hood.
7. Pull up the radiator in the direction of the arrow (1) shown in the figure.
CAUTION:
Removing the shroud panel without supporting it could cause the shroud panel to fall and cause serious injury. Always perform the procedure with at least another person to prevent the shroud panel from falling.
8. Pull down the shroud panel in the direction of the arrow (2) shown in the figure, then remove it from the radiator mount guide.
9. Remove the shroud panel in the direction of the arrow (3) shown in the figure.
CAUTION:
Support the lower surface of the radiator with a jack to prevent the radiator from falling off after the shroud panel is removed.
10. Install in the reverse order of removal.
11. Perform the headlight aiming procedure..
Map Light Removal/Installation
Front Map Light
1. Disconnect the negative battery cable..
2. Open the sunglasses holder.
3. Remove the screws from the front map light.
4. Move the front map light in the direction of the arrow (1) shown in the figure
and pull out the pin from the bracket.
CAUTION:
Be careful ...
Operational Range
The system operates only when the driver is in the vehicle or within operational
range while the key is being carried.
NOTE
When the battery power is low, or in places where there are high-intensity
radio waves or noise, the operational range may become narrower or the system may
not operate ...
Cup Holder
WARNING
Never use a cup holder to hold hot liquids while the vehicle is moving:
Using a cup holder to hold hot liquids while the vehicle is moving is dangerous.
If the contents spill, you could be scalded.
Do not put anything other than cups or drink cans in cup holders:
Putting objects other ...