Mazda CX-5 Service & Repair Manual: Shift Solenoid No.3 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
Shift solenoid No.3 adjusts the hydraulic pressure in the R-3-5 brake circuit based on the current demand from the TCM according to the vehicle conditions.
Construction
-
Shift solenoid No.3 is installed to the solenoid control valve body.
-
Shift solenoid No.3 is a normal open-type linear solenoid.
Operation
-
Adjusts the R-3-5 brake pressure by increasing/decreasing the energization current to shift solenoid No.3 according to the signal from the TCM.
Shift Solenoid No.2 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
Shift solenoid No.2 adjusts the hydraulic pressure in the 2-6 brake circuit
based on the current demand from the TCM according to the vehicle conditions.
Construction
...
Shift Solenoid No.4 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
Shift solenoid No.4 adjusts the hydraulic pressure in the high clutch circuit
and the low and reverse brake circuit based on the current demand from the TCM
according to ...
Other materials:
Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor
No.2 Removal/Installation
NOTE:
Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the
IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2.
1. Disconnect the negative battery cable..
2. Disconnect the MAP sensor/IAT sensor No.2 connector.
3. Remove the MAP sensor/IA ...
Blind Spot Monitoring (Bsm) Off Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the BSM OFF switch..
3. Verify that the resistance between BSM OFF switches B and C is as indicated
in the table.
If the resistance cannot be verified as indicated in the table, replace the
cluster switch.
4. Apply batte ...
Front Frame (Rear) Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 33 locations shown in the figure.
NOTE:
When drilling, do not drill a hole all the way through or there could be
a problem when installing the new part.
2. Remove the front frame (rear). ...
