Outline
The TCM optimizes the hydraulic pressure for clutch engagement and disengagement through learning correction of the clutch engagement pressure.
NOTE:
The clutch engagement pressure learning value stored in the TCM is not cleared even if the negative battery terminal is disconnected. Therefore, if the control valve body is replaced, the learning value stored in the TCM and the control valve body specification are incompatible and engine rev-up may occur or shift shock may increase. Due to this, if the control valve body is replaced, it is necessary to perform the initial learning.
Construction
Operation
The TCM learns engine performance changes resulting from past shifting and deterioration over time of the transaxle and performs learning correction for optimum clutch engagement pressure during initial shifting.
Crash Zone Sensor Removal/Installation [Standard Deployment Control System]
WARNING:
Handling the crash zone sensor improperly can accidentally deploy the air
bags and pre-tensioner seat belts, which may seriously injure you. Read the
air bag system service warnings and cautions before handling the crash zone
sensor..
1. Switch the ignition to off.
...
Meter Hood Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the upper column cover.
3. Using a phillips screwdriver, remove fasteners.
NOTE:
When pulling up the shaft of fasteners using a phillips screwdriver, the
shaft will not be pulled up if it is rotated by pressing the driver. To pull ...
Bumper Slider Removal/Installation
Front Bumper Slider
1. Disconnect the negative battery cable..
2. Remove the seal board upper..
3. Remove the front bumper..
4. Remove bolts A.
5. Pull the front bumper slider in the direction of the arrow while detaching
pins B and hook C.
6. Install in the reverse order of removal ...