Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Shift Lock System Inspection

Shift-Lock System Inspection

1. Switch the ignition ON (engine off).

2. Shift the selector lever to the P position.

3. Verify that the selector lever cannot be shifted from P to R position when the brake pedal is released.

4. Verify that the selector lever can be shifted from P to R position when the brake pedal is depressed.

Shift-Lock Solenoid Inspection

NOTE:

1. Disconnect the negative battery cable..

2. Remove the front console..

3. Reconnect the negative battery cable..

4. Verify that the voltages of each of the selector lever component terminals are as indicated in the table.


Shift-lock solenoid specification

Terminal

Connected to

Test condition

Voltage (V)

A

IG1 relay

Ignition switched ON (engine on)

B+

Except above

Below 1.0

H

Start stop unit

Under any condition

Below 1.0


Shift-lock Override Button Inspection

1. Switch the ignition to off.

2. Verify that the selector lever is in the P position.

3. Without the brake pedal depressed, verify that the selector lever cannot be shifted from the P position.

4. Remove the emergency override hole cover using a tape-wrapped flathead screwdriver.


5. Insert the flathead screwdriver into the emergency override hole and push it down.

6. Verify that the selector lever can be shifted from the P position.

Shift Control Module Removal/Installation [C66 M R]
Removal 1. Shift the shift lever to the neutral position. 2. Remove the plug hole plate.. 3. Disconnect the negative battery cable.. 4. Remove the air cleaner and air hose as a single unit.. ...

Shift Lock System [Fw6 A EL, Fw6 Ax EL]
Purpose, Function The shift-lock system operates when the ignition is switched to ON and the brake pedal is not depressed, and inhibits the selector lever from being shifted from the P po ...

Other materials:

Check Fuel Cap Warning Light
Purpose/Function The check fuel cap warning light is built into the instrument cluster. If the PCM detects that the fuel cap is open, the light illuminates to warn the driver that the fuel cap is open. Construction Built into the instrument cluster.(See INSTRUMENT CLUS ...

Air Bag System Warning Alarm [Two Step Deployment Control System]
Purpose The air bag system warning alarm notifies the driver that a malfunction occurred in the air bag system instead of the air bag system warning light. Function If a malfunction occurs in the air bag system while the air bag system warning light cannot illuminate, the a ...

Rear Window Glass Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. CAUTION: Proper installation of the glass may be difficult if sealant is cracked or the glass is pushed out by air pressure when a door is opened/closed with al ...

© 2016-2022 Copyright www.mcx5.org