Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Set Plate Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the seal board upper..

3. Remove the front bumper..

4. Remove fasteners A.


5. Remove the set plate in the direction of the arrow shown in the figure.

6. Install in the reverse order of removal.

Seal Plate Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the seal board upper.. 3. Remove the front bumper.. 4. Remove fasteners A. 5. Remove the seal plate in the direction of the arrow shown ...

Side Garnish Installation
1. Install clip A. Front Rear 2. Install clip B to the vehicle from the front side. ...

Other materials:

Push Button Start Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the meter hood.. 3. While pressing the push button start tab in the direction of the arrow (1) shown in the figure, push out the push button start in the direction of the arrow (2) shown in the figure to detach the push button start tab fr ...

Discharge Headlight Control Module Removal/Installation
WARNING: Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the service warnings.. 1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the connector. ...

Transfer Oil Inspection [Fw6 Ax EL]
1. Park the vehicle on level ground. 2. Remove the oil level plug with the washer. 3. Checking by hand, verify that the oil is near the brim of the plug hole. If the oil level is low, add the specified amount and type of oil through the oil level plug hole. Transfer oil ...

© 2016-2022 Copyright www.mcx5.org