Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Parking Brake Switch Inspection

1. Disconnect the parking brake switch connector. 2. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the parking brake switch. ...

Brake Fluid Level Sensor Inspection

1. Disconnect the brake fluid level sensor connector from the master cylinder. 2. Inspect for continuity according to fluid level between the brake fluid level sensor terminals. If no ...

Other materials:

Quarter Window Glass Removal
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. e. D-pillar trim. f. C-pillar trim. 3. Apply protective tape along the edge of the body and the quarter window glass. WARNING: ...

Shift Solenoid No.4 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function Shift solenoid No.4 adjusts the hydraulic pressure in the high clutch circuit and the low and reverse brake circuit based on the current demand from the TCM according to the vehicle conditions. Construction Shift solenoid No.4 is installed to the solenoid c ...

Automatic Transaxle Removal/Installation [Fw6 Ax EL]
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor (axle side) and ...