Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Sunroof Switch Removal/Installation

NOTE: The sunroof switch is together with the front map light. 1. Disconnect the negative battery cable.. 2. Remove the front map light.. 3. Install in the reverse order of removal. ...

Sunroof Switch Inspection

1. Disconnect the negative battery cable.. 2. Remove the front map light.. 3. Verify that the continuity between the sunroof switch terminals is as indicated in the table. If not as ...

Other materials:

Windshield Wipers and Washer
The ignition must be switched ON. WARNING Use only windshield washer fluid or plain water in the reservoir: Using radiator antifreeze as washer fluid is dangerous. If sprayed on the windshield, it will dirty the windshield, affect your visibility, and could result in an accident. Only use wind ...

Transfer Removal/Installation [Fw6 Ax EL]
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor (axle side) and ...

Filament Inspection
1. Switch the ignition ON (engine off). 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the tester could damage it. Wrap aluminum foil around the end of the lead and inspect the filament by touching it ...