Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Turn Signal/Hazard Warning Indicator Lights

Purpose Notifies the driver that a turn light, the hazard warning lights are flashing. Function Flashes according to the turn switch and hazard warning switch operations. Con ...

Adaptive Front Lighting System (Afs) Off Switch Inspection

1. Disconnect the negative battery cable.. 2. Remove the switch panel.. 3. Verify that the resistance between AFS OFF switches B and C is as indicated in the table. If the resist ...

Other materials:

Coupler Component Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes. ...

Front Crossmember Removal/Installation
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor wiring ha ...

PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “BSML” or “BSMR”. 3. Select the applicable PID from the PID table. 4. Ve ...