Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays

Theft Deterrent Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). 3. Disconnect the connector. 4. Remove t ...

Door Lock Switch Inspection

Driver's Side 1. Disconnect the negative battery cable.. 2. Remove the door lock switch.. 3. Verify that the continuity is as indicated in the table. If the continuity is not ...

Other materials:

Keyless Antenna [Advanced Keyless Entry System]
Purpose Outputs a request signal and specifies the remote transmitter location. Function The keyless antenna outputs request signals to the inside and outside of the vehicle based on the signals from the LF control unit. Construction, Operation The antennas for re ...

Rear Seat Center Armrest Removal/Installation
1. Operate the push knob (RH) and lower the rear seat back (RH). 2. Remove screw A. 3. Remove the rear seat center armrest hinge cover (RH) in the direction of the arrow (1) shown in the figure while setting hook A aside. 4. Remove bolt B. 5. Remove the rear seat center armrest in ...

Liftgate Upper Trim Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the liftgate upper trim in the direction of the arrow (1) shown in the figure, then detach clips B, clip C and pin D while pulling in the direction of the arrow (2). 2. Take the shaded area shown in the figure, detach ...