Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Secondary Gear [Fw6 A EL, Fw6 Ax EL]

Purpose/Function

Construction

Reduction Gear
Purpose/ Function The reduction gear transmits the rotation input from the EPS motor, decreasing the rotation speed and increasing the torque simultaneously. Construction The re ...

Selector Lever Inspection
1. Switch the ignition ON (engine off or on). 2. Perform the following procedures to inspect the selector lever. If there is any malfunction, adjust the selector cable.. a. Verify that ...

Other materials:

Air Intake Actuator [Full Auto Air Conditioner]
Purpose The air intake actuator moves the air intake door in the blower unit to switch the air intake port. Function The air intake actuator drives the motor based on the signal from the climate control unit and moves the air intake door to the FRESH or REC position. ...

Rear Seat Back Striker Removal/Installation
1. Disconnect the negative battery cable.. 2. Press the push knob to fold the rear seat back. 3. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. 4. Remove the bolts. 5. Remove the rear seat back striker. 6. Install in the ...

Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Two Step Deployment Control System]
WARNING: A live (undeployed) air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury. Always refer to the “AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES” and ...

© 2016-2022 Copyright www.mcx5.org