Mazda CX-5 Service & Repair Manual: Seats

Roof Molding Removal

1. Insert a tape-wrapped flathead screwdriver in the position shown in the figure. 2. Rotate a tape-wrapped flathead screwdriver in the direction of the arrow in the order of (1), (2) shown in th ...

Front Seat

Purpose, Function The front seats are structured to reduce impact force applied to the head of the occupant in a vehicle collision. 8WAY or 6WAY power seats have been adopted on the ...

Other materials:

Suspension
49 T034 1A0 Coil spring compressor set 49 T028 3A0 Ball joint puller set 49 G033 102 Handle 49 U034 204 Dust boot installer 49 FT01 389 Pr ...

Condenser Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim (LH). c. Rear scuff plate (LH). d. Trunk side trim (LH). e. D-pillar trim (LH). 3. Disconnect the connector. 4. Remove the bolts. 5. Remove the condenser. 6. Install in ...

Car Navigation Unit Removal/Installation
CAUTION: The audio unit communicates with the car-navigation unit and records the presence/non-presence of the car-navigation unit when the ignition is switched to ACC or ON (engine off or on) after connecting the negative battery cable. If the commander switch is installed ...