Mazda CX-5 Service & Repair Manual: Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]
CAUTION:
-
When the seat weight sensor is replaced with a new one, perform the seat weight sensor calibration using the M?MDS..
-
When replacing the seat weight sensor, replace it together with the passenger-side seat slide adjuster (because seat weight sensor is integrated with passenger-side seat slide adjuster).
(See FRONT SEAT ADJUSTER UNIT REMOVAL/INSTALLATION.)
Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION:
If any of the following work is performed, perform the seat weight sensor
inspection using the M-MDS.
Removal of the passenger-side seat
Loosening and retig ...
Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING:
Handling the air bag module improperly can accidentally operate (deploy)
the air bag module, which may seriously injure you. Read the air bag system
service warnings and caution ...
Other materials:
Plug Hole Plate Removal/Installation
CAUTION:
If the rubber on only one side of the plug hole plate front is lifted up,
it could damage the adapter at the location shown in the figure. When removing
the plug hole plate, lift up the rubbers at the same time.
Removal
1. Pull up the front part of the plug hole p ...
Crankshaft Position (CKP) Sensor Removal/Installation
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. Be sure there is no foreign material on the CKP sensor when
replacing.
Do not assemble t ...
Fuel Injector Removal/Installation
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin and eyes. To prevent this, always complete the “Fuel
Line Safety Procedure”, while referring ...
