1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1min or more
..
3. Remove the front driver’s seat..
4. Disconnect the connector from the seat track position sensor by pressing the connector tab and pulling out the lock lever in the direction of the arrow.
When connecting the seat track position sensor connector, insert the lock lever (connector disconnection prevention lever) completely.
5. Remove the screw.
6. Detach the tab while lifting up the seat track position sensor in the direction of the arrow (1).
7. Rotate the seat track position sensor in the direction of the arrow (2).
8. Rotate the seat track position sensor in the direction of the arrow (3).
9. Remove the seat track position sensor (4).
10. Install in the reverse order of removal.
11. Switch the ignition ON (engine off or on).
12. Verify that the air bag system warning light illuminates for approx. 6 s
and goes out.
If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system..
Propeller Shaft Inspection
1. Measure the propeller shaft center runout using the dial gauge.
If it exceeds the maximum specification, replace the propeller shaft as a
single component.
Propeller shaft maximum runout
0.8 mm {0.031 in}
2. Inspect the play and rotation of the joint by turning ...
Manual Air Conditioner Control System [Manual Air Conditioner]
Outline
The climate control unit performs the following controls based on the signals
from each switch/dial and the sensor.
A/C compressor control
Defroster control
Block Diagram
Outline of Control System
Manual air conditioner has the follo ...
Camshaft Position (CMP) Sensor Inspection
Intake CMP Sensor
Visual inspection
CAUTION:
When replacing the CMP sensor, make sure there is no foreign material on
it such as metal shavings. If it is installed with foreign material, the sensor
output signal will malfunction resulting from fluctuation in magnetic flux and
caus ...