Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Seat Belt Inspection

Belt

1. Verify that the belt is installed properly with no twists or kinks.

2. Verify that there is no damage to the seat belt and no deformation of the metal fittings.

ELR (Emergency Locking Retractor)

Except rear center seat belt

1. Verify that the belt can be pulled out smoothly, and that it retracts smoothly.


2. Verify that the retractor locks when the belt is pulled quickly.

3. Remove the retractor.

4. While pulling the seat belt out, make sure that the seat belt does not lock when the retractor is tilted slowly up to 15В°

from the mounted position and locks when the retractor is tilted 40В° or more.


Rear center seat belt

CAUTION:

1. Fasten the rear center seat belt to the rear buckle (center) and pull out the rear center seat belt 130 mm {5.12 in}

.


2. Verify that the belt can be pulled out smoothly, and that it retracts smoothly.

3. Verify that the retractor locks when the belt is pulled quickly.

4. Remove the retractor.

5. While pulling the seat belt out, make sure that the seat belt does not lock when the retractor is tilted slowly up to 15В°

from the mounted position and locks when the retractor is tilted 40В° or more.


ALR (Automatic Locking Retractor)

1. Pull the belt out fully to change the lock mode from ELR to ALR.

2. Verify that retractor makes a clicking sound as the belt slowly retracts. If no sound is heard, the lock mode has not changed to ALR. If necessary, repeat Step 1.

3. Verify that the retractor locks when pulled.

4. Verify that the lock mode changes to ELR when the belt is fully pulled out.

Load Limiter Retractor

WARNING:

1. If the vehicle has been subjected to a shock in an accident, pull the belt from the retractor and confirm that there are no wear tracks (the load limiter has not operated) by visually inspecting and feeling the belt.


Seat Belt
Outline (Standard Deployment Control System) Three-point front seat belts with the following functions for front seat passengers adopted. ELR (Emergency Locking Retractor: emerg ...

Steering
...

Other materials:

Front Door Speaker Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Inner garnish. b. Front door trim. 3. Disconnect the front door speaker connector.. 4. Verify that the resistance and continuity between the front door speaker terminals is as indicated in the table. ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the output shaft (primary gear). The turbine/input shaft speed sensor and output shaft speed ...

Power Metal Oxide Semiconductor Field Effect Transistor (Power Mos Fet) [Full Auto Air Conditioner]
Purpose The power MOS FET controls the blower motor rotation speed. Function The power MOS FET controls the supply voltage to the blower motor based on the gate voltage sent from the climate control unit, and adjusts the fan rotation speed (airflow volume). Constructi ...

© 2016-2022 Copyright www.mcx5.org