Mazda CX-5 Service & Repair Manual: Seat
Outline
Front seat
-
A manual seat or power seat has been adopted on the driver's seat.
-
A seat warmer system has been adopted on the front seats. (with seat warmer system)
-
A manual seat has been adopted on the front passenger's seat.
-
A side air bag module is built into the front seats.
-
S-shaped springs have been adopted in the front seat cushions.
Rear seat
-
6:4 split type or 4:2:4 split type seats have been adopted on the rear seats.
-
A center armrest has been adopted on the 4:2:4 split-type rear seat's center seat.
-
Large-sized cup holders have been adopted on the center armrest.
-
The following two types of child restraint seat anchors have been adopted which enable securing of ISO FIX-applicable child restraint seats on the rear seat.
-
Top tether anchor
-
ISO FIX anchor
Structural view
Remote Handle Lever Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
3. Disconnect the remote cable on the ...
Seat Track Position Sensor Removal/Installation [Two Step Deployment Control
System]
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1min or more..
3. Remove the front driver’s seat..
4. Disconnect the connector from the seat track positio ...
Other materials:
Key Warning Light (Red)/Key Indicator Light (Green)
Purpose
KEY warning light (red)
The KEY warning indicator light (red) notifies the user that the engine cannot
be started, the remote transmitter is outside of the vehicle, or that there
is a malfunction in the system.
KEY indicator light (green)
The KEY indicator light (g ...
Throttle Position (TP) Sensor Inspection
Voltage Inspection
CAUTION:
The inspection cannot be performed with this method correctly if there is
a malfunction of the APP sensor or throttle valve actuator. Verify that no DTCs
related to the APP sensor or throttle valve actuator are stored before the inspection.
NOTE:
...
Engine Coolant Protection Inspection
1. Measure the engine coolant temperature and specific gravity using a thermometer
and a hydrometer.
CAUTION:
Use engine coolant at a concentration that meets the environmental conditions
in which the vehicle is driven, otherwise engine damage could occur.
The engine has alumi ...
