Mazda CX-5 Service & Repair Manual: Seal Board Upper Removal/Installation
1. Remove fasteners A.
2. Pull the seal board upper in the direction of the arrow in the order of (1), (2) and remove it while detaching hooks B.
3. Install in the reverse order of removal.
Sail Garnish Removal/Installation
1. Open the front door.
2. Affix protective tape to the position shown in the figure.
3. Insert a tape-wrapped flathead screwdriver into the shown in the figure and
remove the clip A in the ...
Seal Plate Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the seal board upper..
3. Remove the front bumper..
4. Remove fasteners A.
5. Remove the seal plate in the direction of the arrow shown ...
Other materials:
Liftgate Hinge Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear scuff plate.
b. Trunk end trim.
c. Trunk side trim.
d. C-pillar trim.
e. D-pillar trim.
f. Liftgate.
3. Remove fasteners.
4. While partially peeling back the rear part of the headliner, remove nut ...
Crankshaft Pulley
Purpose, Function
The crankshaft pulley transmits the drive force to the auxiliary parts via
the drive belt.
The crankshaft pulley suppresses torsional vibration of the crankshaft.
Construction
The crankshaft pulley is installed to the front of the crankshaft.
...
Canister Vent (Cv) Solenoid Valve Removal/Installation
U.S.A. And CANADA
1. Disconnect the negative battery cable..
2. Remove the floor under cover (LH)..
3. Disconnect the evaporative hose No.2..
4. Remove in the order indicated in the table.
1
CV solenoid valve connector
2
CV solenoid va ...
