Mazda CX-5 Service & Repair Manual: Sail Garnish Removal/Installation
1. Open the front door.
2. Affix protective tape to the position shown in the figure.
3. Insert a tape-wrapped flathead screwdriver into the shown in the figure and remove the clip A in the direction of arrow (1).
4. Pull the sail garnish in the direction of the arrow (2) and remove it while detaching clips B.
5. Install in the reverse order of removal.
Repairable Range Of Polypropylene Bumpers [Plastic Body Parts]
The three types of damaged bumpers shown below are considered repairable. Although
a bumper which has been damaged greater than this could also be repaired, it should
be replaced with a new one be ...
Seal Board Upper Removal/Installation
1. Remove fasteners A.
2. Pull the seal board upper in the direction of the arrow in the order of (1),
(2) and remove it while detaching hooks B.
3. Install in the reverse order of removal. ...
Other materials:
Warning Sound is Activated
Lights-On Reminder
If lights are on and the ignition is switched to ACC or the ignition is switched
off, a continuous beep sound will be heard when the driver's door is opened.
NOTE
• When the ignition is switched to ACC,
the “Ignition Not Switched Off (STOP) Warning Beep” ove ...
Glass Antenna
Purpose, Function
The RDS (Radio Data System) converts radio broadcast waves to electric signals
and sends the signals to the audio unit.
Construction
An antenna with excellent noise resistance has been adopted to the rear window
glass.
Fail-safe
Function n ...
Clock Spring Removal/Installation [Two Step Deployment Control System]
CAUTION:
If the disc on the combination switch is deformed or has foreign material
adhering to it, performance of the steering angle sensor may be reduced, causing
abnormal operation. When handling the clock spring, be careful not to deform
the disc and make sure there is no foreign ...
