Mazda CX-5 Service & Repair Manual: Rust Preventive Treatment [Water Proof And Rust Preventive]

Room Straight Line Dimensions (3) [Dimensions]

Point symbol Designation Hole diameter or bolt or nut size mm {in} A Rear seat installation hole ?14 {0.55} ...

Side Member Installation [Panel Replacement]

Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before inst ...

Other materials:

Active Command Modes Inspection [Rear Body Control Module (Rbcm)]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “R_BCM”. 3. Select the simulation items from the PID table. 4. Perform the a ...

Front Door Speaker Removal/Installation
Without Bose® NOTE: If the procedure is performed while holding the front door speaker cone, it could deform the cone causing a malfunction. Therefore, perform the procedure while holding any part other than the cone. 1. Disconnect the negative battery cable.. 2. Remove the f ...

Theft Deterrent Horn Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk end trim. b. Rear scuff plate (RH). c. Trunk side trim (RH). d. Theft-deterrent horn. 3. Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the f ...