Mazda CX-5 Service & Repair Manual: Room Light Control System

Mazda CX-5 Service & Repair Manual / Engine / Control / Room Light Control System

Outline

The room light control system changes the illumination condition and illumination level of the interior lights (door position) according to whether the doors are opened/closed and locked/unlocked.
The room light control system is controlled by the rear body control module (RBCM).
The rear body control module (RBCM) performs room light control system fail-safe..

Structural View

System Wiring Diagram

Operation


Operation condition	Interior light		Lights off condition (Any of the following conditions is met)
Operation condition	Illumination period	Brightness level
Condition detected in which any door is opened (any door latch switch is on) from condition in which ignition is switched OFF or in ACC position, and all doors are closed (all door latch switches and door switches are off).	Approx. 30 min	100 %	All doors closed except for liftgate (All door latch switches and door switches are off) After illumination time elapses *1
All doors are closed (all door latch switches and door switches are off), and driver's door lock knob is unlocked from lock	Approx. 30 s	100 %	Ignition is switched ON Lock driver's door lock knob (Door lock link switch is in lock position) After illumination time elapses
Condition detected in which ignition is switched off (LOCK) with ignition switched ON (engine off or on)	Approx. 30 s	100 %	Ignition is switched ON After illumination time elapses
Condition detected in which all doors are closed (all door latch switches and door switches are off) from a condition in which the ignition is switched OFF or in ACC position and any door is opened.	Approx. 15 s	60 %	Ignition is switched ON Lock driver's door lock knob (Door lock link switch is in lock position) After illumination time elapses

*1 After the interior light is turned off according to the cancel conditions, it turns on again if any one of the following conditions is met.

After all doors are closed, any door is re-opened (after all door latch switches and door switches are off, any door latch switch and door switch is on)
Ignition is switched ON

?: With room light control system—: No airflow


Type	Installation position	Room light control system
Front map light	Front area of roof	?
Rear map light	Center area of roof	?
Cargo compartment light	Cargo compartment	-
Vanity mirror illumination	Sunvisor	-
Glove compartment light	Passenger's side floor panel	-

Purge Control

Outline An appropriate amount of evaporative gas is fed into the intake manifold by the purge solenoid valve operation according to the engine operation conditions. This ensures driveabil ...

Sas Control Module Configuration (Using As Built Data) [Standard Deployment Control System]

NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the ...

Other materials:

Auxiliary Jack/Usb Port Inspection
Auxiliary jack inspection 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper console. b. Auxiliary jack/USB port. 3. Connect a commercially-available plug to the external input unit. 4. Verify that the continuity between the external input unit terminal ...

Cooling System
Outline Passing water resistance is reduced by improvement of the engine coolant passage shape. Pump efficiency is improved by changing the water pump impeller to the closed impeller. Structural View Flow Chart Structure Consists of the followi ...

Tire Pressure Monitoring System Set Switch
Purpose The tire pressure monitoring system set switch is used to initialize the tire pressure monitoring system. Construction, Operation The tire pressure monitoring system set switch is installed to the instrument panel. The tire pressure monitoring sy ...