Mazda CX-5 Service & Repair Manual: Refrigerant Line

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Refrigerant Line

Purpose

The system piping connects each related part of the refrigerant system.

Construction

Block-type piping has been adopted to the pipe connection, improving the efficiency of piping related servicing.
The pipes in the piping system consist of the following parts.

Cooler hose (HI)
Cooler hose (LO)
Cooler pipe

The pipes in the piping system are made of aluminum alloy and the hoses are made of rubber (flexible hose).
A high-pressure charging valve is located on the cooler pipe (HI) and a low-pressure charging valve is located on the cooler pipe (LO).

Fail-safe

Function not equipped.

Refrigerant Charging

CAUTION: Do not use a different type of refrigerant or charge beyond the specified level. Otherwise, cooling ability will be lowered and the A/C compressor could be damaged. Chargi ...

Refrigerant Line Removal/Installation

1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Disconnect the engine ground. 4. Disconnect the refrigerant pressure sensor connector. 5. Remove in the order i ...

Other materials:

Warm Up Three Way Catalytic Converter (Wu Twc) Inspection
CAUTION: Perform the following procedures, DTC P0421:00 is indicated only. 1. Connect the M-MDS to the DLC-2. 2. Start the engine and warm it up to normal operating temperature. 3. Turn off the engine. 4. Verify that the engine compression is within the specification.. If ...

Differential Oil Temperature Sensor
Purpose, Function The differential oil temperature sensor detects the rear differential oil temperature based on the resistance of the thermistor, and inputs it to the AWD CM. Construction The differential oil temperature sensor is installed in the rear differential carr ...

Engine Disassembly/Assembly
CAUTION: When the transaxle is installed, do not suspend the engine. Otherwise, the SST installation area of the cylinder head may be damaged due to excess weight. Only suspend the engine after separating the engine and transaxle. Applying excessive force (force of 100 N {10.2 ...