Mazda CX-5 Owners Manual: Rear Window Defroster
The rear window defroster clears frost, fog, and thin ice from the rear window.
The ignition must be switched ON.
Press the switch to turn on the rear window defroster. The rear window defroster operates for about 15 minutes and turns off automatically.
The indicator light illuminates during operation.
To turn off the rear window defroster before the 15 minutes has elapsed, press the switch again.
Fully Automatic Type Climate Control
Manual Type Climate Control
CAUTION
Do not use sharp instruments or window cleaners with abrasives to clean the inside of the rear window surface. They may damage the defroster grid inside the window.
NOTE
This defroster is not designed for melting snow.
If there is an accumulation of snow on the rear window, remove it before using the defroster.
Mirror Defroster
To turn on the mirror defrosters, switch the ignition ON and press the rear window defroster switch .
Rear Window Wiper and Washer
The ignition must be switched ON.
Rear WindowWiper
Turn the wiper on by turning the rear wiper/washer switch.
Rear WindowWasher
To spray washer fluid, turn the rear wiper/ washer switch to the ...
Horn
To sound the horn, press the mark
on the steering wheel. ...
Other materials:
Brake System/ABS Warning Light
Purpose/Function
The brake system/ABS warning light is built into the instrument cluster.
If a malfunction is detected in the system with the parking brake released,
the warning light illuminates to notify the driver.
Construction/Operation
When the DSC system and CAN l ...
When Liftgate Cannot be Opened
When Liftgate Cannot be Opened
If the vehicle battery is dead or there is a malfunction in the electrical system
and the liftgate can not be opened, perform the following procedure as an emergency
measure to Open it: 1. Remove the cap on the interior surface of the liftgate with
a flathead sc ...
Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1.
1. Disconnect the negative battery cable..
2. Disconnect the MAF sensor/IAT sensor No.1 connector.
3. Remove the MAF sensor/IA ...
