Mazda CX-5 Service & Repair Manual: Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the front over fender..
3. Remove the mudguard (RH)..
4. Disconnect the rear washer hose A from the washer motor.
5. Remove the rear washer hose A from the washer tank hook.
6. Remove the rear washer hose A from clips A and B.
7. Disconnect the rear washer hose A from the joint pipe A and remove it.
8. Disconnect the rear washer hose B from the joint pipe A.
9. Remove the sunroof seaming welt. (with sunroof).
10. Remove the A pillar trim..
11. Disconnect the rear washer hose B from the joint pipe B and remove it.
12. Disconnect the rear washer hose C from the joint pipe B.
13. Remove the following parts:
a. Map light.
b. Sunvisor.
c. Front scuff plate.
d. Rear scuff plate.
e. B-pillar lower trim.
f. Front seat belt adjusting cover.
g. Front seat belt upper anchor installation bolt.
h. B-pillar upper trim.
i. Assist handle.
j. Trunk board.
k. Trunk end trim.
l. Trunk side trim.
m. D-pillar trim.
n. C-pillar trim.
o. Headliner.
14. Remove the tape and clips shown in the figure.
Without sunroof
With sunroof
15. Disconnect the rear washer hose C from the joint pipe C and remove it.
16. Disconnect the rear washer hose D from the joint pipe C.
17. Remove the liftgate upper trim..
18. Partially peel the liftgate grommet in the direction of arrow (1) shown in the figure, and remove the liftgate grommet from the liftgate grommet inner.
19. Using a tape-wrapped precision flathead screwdriver, press the liftgate grommet inner tabs in the directions of arrows (2) and (3) shown in the figure and remove each liftgate grommet inner from the liftgate and vehicle side in the direction of arrow (4).
20. Disconnect the rear washer hose D from the rear washer nozzle and remove it.
21. Install in the reverse order of removal.
Washers
...
Rear Washer Nozzle Adjustment
CAUTION:
If the nozzle angle is adjusted with excessive force by strongly inserting
a needle or similar thin tool into the injection nozzle of rear washer nozzle,
it could damage the noz ...
Other materials:
Clutch Release Cylinder Removal/Installation [C66 M R]
CAUTION:
Do not allow clutch fluid to get on a painted surface. Clutch fluid contains
properties which can dissolve the paint. If clutch fluid gets on a painted surface,
wash it off with water immediately and wipe the area off completely.
1. Remove the front under cover No.2..
...
Air Bag System Warning Light [Two Step Deployment Control System]
Purpose
The air bag system warning light notifies the driver of a malfunction in
the SRS air bag system.
Function
If a malfunction occurs in the SRS air bag system, the air bag system warning
light illuminates or flashes.
Construction
LEDs (light-emitting d ...
Passenger Side Air Bag Module [Two Step Deployment Control System]
Purpose
When the passenger-side air bag module receives an impact from a frontal
or frontal offset collision, the operation (deployment) of the air bag mediates
the impact to the head and face of the front passenger.
Function
When the passenger-side air bag module receives ...