Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Trailing Link Removal/Installation

Mazda CX-5 Service & Repair Manual / Suspension / General / Rear Trailing Link Removal/Installation

1. Remove the floor under cover..

2. Disconnect the rear parking cable..


3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

5. Inspect the wheel alignment and adjust it if necessary..



1

Rear trailing link installation nut

2

Rear trailing link installation bolt

3

Rear trailing link

(See Rear Trailing link Installation Note.)


Rear Trailing link Installation Note

1. Install the rear trailing link installation bolts using a jack.


2. Install the rear trailing link installation nut.

General Procedures (Suspension)
Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening torque 108—14 ...

Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and suspend it out of the way using a cable. 2. Remove the disc plate. 3. Remove the wheel hub bolt using the SST as shown in the figure. 4. Place ...

Other materials:

Antenna Feeder No.3 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate. b. Rear scuff plate. c. B-pillar lower trim. d. Front seat belt adjusting cover. e. Front seat belt upper anchor installation bolt. f. B-pillar upper trim. g. Rear seat cushion. h. Trunk ...

Clock Spring Removal/Installation [Standard Deployment Control System]
CAUTION: If the disc on the combination switch is deformed or has foreign material adhering to it, performance of the steering angle sensor may be reduced, causing abnormal operation. When handling the clock spring, be careful not to deform the disc and make sure there is no foreign ...

Oil Control Valve (OCV) [Skyactiv G 2.0]
Purpose, Function The OCV switches the oil passage to the hydraulic variable valve timing actuator to control the opening/closing period of the exhaust valve. Construction The OCV is installed to the exhaust camshaft cap (No.1). The OCV consists of a spool valve wh ...

© 2016-2022 Copyright www.mcx5.org