WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife.
1. Remove the rear door garnish. (rear side).
2. Remove the double-sided adhesive tape in the position shown in the figure using the utility knife.
CAUTION:
When remove the double-sided adhesive tape, be careful not to damage clip A.
3. Insert a tape-wrapped flathead screwdriver shown in the figure and remove the protector in the direction of arrow (1).
4. Insert a tape-wrapped flathead screwdriver shown in the figure and remove clips A in the direction of arrow (2).
5. Remove the rear sash molding in the direction of arrow in the order of (3), (4) shown in the figure.
Transmission/Transaxle SST
1: Mazda SST number
2: Global SST number
Example
1:49 UN30 3009
2:303-009
Crankshaft damper remover
Clutch [C66M-R]
1:49 E011 1A0
2: –
Ring gear brake set
1:49 SE01 310A
2: –
Clutch disc center ...
Power Brake Unit Removal/Installation
CAUTION:
Once the brake switch clearance has automatically been adjusted, it cannot
be adjusted again. Therefore, replace the switch with a new one when replacing
the power brake unit or performing any procedure that changes the pedal stroke.
1. Remove the battery and battery tra ...
Differential Oil Temperature Sensor Inspection
WARNING:
Hot differential oil may cause severe burns. Do not perform maintenance while
differential oil is hot.
1. Disconnect the negative battery cable.
2. Disconnect the differential oil temperature sensor connector and remove the
differential oil temperature sensor.
3. Wrap ...