Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Parking Brake Cable Removal/Installation

Mazda CX-5 Service & Repair Manual / Brakes / Parking Brake / Rear Parking Brake Cable Removal/Installation

1. Remove the front console box..

2. Remove the shift lever knob. (MTX).

3. Remove the shift panel..

4. Remove the upper panel..

5. Remove the rear console..

6. Loosen the adjusting nut.

7. Remove the floor under cover No.2..

8. Remove in the order indicated in the table.

9. Install in the reverse order of removal.

10. After installation, inspect the parking brake lever stroke..



1

Nut

2

Nut

3

Bolt

4

Nut

5

Rear parking brake cable

(See Rear Parking Brake Cable Removal Note.)

(See Rear Parking Brake Cable Installation Note.)


Rear Parking Brake Cable Removal Note

1. Remove the rear parking brake cable from the front parking brake cable..

2. Remove the rear parking brake cable from the rear caliper.

3. Remove the rear parking brake cable.

Rear Parking Brake Cable Installation Note

1. Install the rear parking brake cable to the rear caliper.

2. Verify that the outer end tabs of the rear parking brake cable is securely engaged with the bracket.


Parking Brake System
Outline A center lever type parking brake has been adopted, improving operability. Serviceability has been improved by enabling adjustment of the parking brake lever from the vehicle ...

Parking Brake Switch Inspection
1. Disconnect the parking brake switch connector. 2. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the parking brake switch. ...

Other materials:

Front Fender Junction Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

Glove Compartment Removal/Installation
1. Push the glove compartment in the direction of the arrow (1) and remove hooks A. 2. Pull the stay damper in the direction of the arrow (2) shown in the figure and remove the hook B. CAUTION: If the glove compartment is closed without being joined to the stay damper, the sta ...

Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. B-pillar lower trim. b. Front seat belt adjusting cover. c. Front seat belt upper anchor installation bolt. d. B-pillar upper trim. e. Trunk board. f. Trunk end trim. g. Trunk side trim. h. D-pillar trim. ...

© 2016-2022 Copyright www.mcx5.org