Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Oil Seal Replacement

Mazda CX-5 Service & Repair Manual / Engine / Lubrication / Rear Oil Seal Replacement

1. Remove the transaxle..

2. Remove the flywheel (MTX) or the drive plate (ATX)..

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.



1

Rear oil seal

(See Rear Oil Seal Removal Note.)

(See Rear Oil Seal Installation Note.)


Rear Oil Seal Removal Note

1. Cut the oil seal lip using a utility knife.

2. Remove the oil seal using a flathead screwdriver with the tip protected by a clean cloth to prevent damage to the oil seal sliding part of the crankshaft.


Rear Oil Seal Installation Note

1. Apply clean engine oil to the inner surface of a new rear oil seal.

2. Insert the rear oil seal into the cylinder block by hand.

3. Tap the oil seal in evenly using the SST

and a hammer.



Oil Strainer
Purpose, Function The oil strainer suctions the engine oil in the oil pan using the oil pump vacuum. The engine oil is filtered by the internal filter at that time. Construction ...

Oil Pressure Switch Inspection
1. Switch the ignition ON (engine off) and verify that the oil pressure warning light is illuminated. 2. Start the engine and verify that the oil pressure warning light turns off. If the ...

Other materials:

Power Outer Mirror System
Outline Power outer mirrors which can be operated remotely have been adopted. Structural view System wiring diagram Function Mirror glass adjustment function Outer mirror glass can be adjusted up/down and left/right electrically. Operation Mirror glass adjustmen ...

Rear Upper Arm Removal/Installation [Awd]
WARNING: Verify that the crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-speed sensor ...

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (driver-side). b. Front side trim (driver-side). c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. ...

© 2016-2024 Copyright www.mcx5.org