Mazda CX-5 Service & Repair Manual: Rear Mount Camera Removal/Installation
CAUTION:
-
The audio unit communicates with the rear mount camera and records the presence/non-presence of the rear mount camera when the ignition is switched to ACC or ON (engine off or on) after connecting the negative battery cable.
-
If the commander switch is installed with the negative battery cable connected when the audio unit records that there is no rear mount camera, the rear mount camera does not operate.
-
For the rear mount camera installation/removal, disconnect the negative battery cable, switch the ignition to ACC or ON (engine off or on) after the servicing is completed, and the audio unit records the presence/non-presence of the rear mount camera.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate recess.
d. Liftgate lower trim.
e. Liftgate garnish.
3. Press the back monitor camera tabs in the direction of the arrows (1) shown in the figure, pull the back monitor camera in the direction of the arrow (2) shown in the figure, and disengage the back monitor camera tabs from the liftgate garnish.
4. Remove the rear mount camera.
5. Install in the reverse order of removal.
Rear Mount Camera Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
d. Liftgate garnish.
e. Rear mount camera. ...
Sirius Satellite Radio Unit
Purpose
Satellite radio programming can be listened to.
Function
The voltage signal sent from the center roof antenna (SIRIUS satellite radio
antenna) is output to the audio uni ...
Other materials:
Wiper Blades
CAUTION
●Hot waxes applied by automatic car washers
have been known to affect the wiper's ability to clean windows.
● To prevent damage to the wiper blades,
do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
● When the wiper lever is in the ...
Inspection Of SST (Deployment Tool) [Standard Deployment Control System]
1. Before using the SST (49 H066 002), inspect its operation.
Inspection Procedure
1. Follow the steps below to inspect the SST (49 H066 002).
If not as indicated in the table, replace the SST (49 H066 002) because
it has a malfunction.
WARNING:
Do not use a malfu ...
Oil Filter Replacement
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous.
It can slip or fall, causing death or serious injury. Never work ...
