Mazda CX-5 Service & Repair Manual: Rear Door Latch And Lock Actuator Inspection
-
The following actuator and switch are integrated with the rear door latch and lock actuator.
-
From the actuator/switch name and operation in the following table, select the actuator or switch to be inspected, and perform the inspection following the inspection procedure described in the reference.
|
Actuator/Switch name |
Operation |
Reference |
|
Rear door lock actuator |
Electrically switches the lock/unlock of the rear doors. |
REAR DOOR LOCK ACTUATOR INSPECTION |
|
Rear door lock-link switch |
Turns on/off in conjunction with the lock/unlock so that the lock/unlock condition is detected. |
DOOR LOCK-LINK SWITCH INSPECTION |
|
Rear door latch switch |
Turns on/off in conjunction with the latch lever operation so that the rear door open/closed condition is detected. |
REAR DOOR LATCH SWITCH INSPECTION |
Rear Door Hinge Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear door.
b. Front scuff plate.
c. Rear scuff plate.
d. B-pillar lower trim.
3. Remove in the order shown in t ...
Front Door Trim Disassembly/Assembly
Driver-side
1. Disassemble in the order shown in the figure.
1
Switch panel cover
2
Power window main switch
(See Power Window Main Switch ...
Other materials:
Purge Control
Outline
An appropriate amount of evaporative gas is fed into the intake manifold
by the purge solenoid valve operation according to the engine operation conditions.
This ensures driveability and prevents release of evaporative gas into the atmosphere.
The PCM drives the purge so ...
Airflow Temperature Control [Full Auto Air Conditioner]
Purpose
The airflow temperature control changes the airflow temperature according
to the vehicle conditions.
Function
The air mix actuator is driven and the air mix door position is changed according
to the set temperature and the vehicle environment.
The climate co ...
Windshield Wiper Motor Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
Windshield Wiper Motor Inspection
1. Apply battery positive voltage and connect the ground to the windshield wiper
motor terminals as indicated in the table below a ...
