Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Door Checker Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Doors/Lids & Hood/Trunk / Rear Door Checker Removal/Installation

1. Fully close the rear door glass.

2. Disconnect the negative battery cable..

3. Remove the rear door trim..

4. Remove the rear door speaker..

5. Remove bolt.


6. Remove nuts.


7. Pull out the rear door checker from the rear speaker installation hole.

8. Install in the reverse order of removal.

Meter Hood Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the upper column cover. 3. Using a phillips screwdriver, remove fasteners. NOTE: When pulling up the shaft of fasteners using a phill ...

Rear Door Garnish Removal/Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. Front 1. Using a tape-wrapped fastener remover, remove clips A in the ...

Other materials:

Liftgate Latch Switch
Purpose, Function The switch turns on/off in conjunction with the rotation of the latch lever, and it detects the open/closed condition of the liftgate by the voltage value which is changed by the rear body control module (RBCM). Construction The switch is turned on/off by ...

Rear Side Marker Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover, and detach the serv ...

Ignition Switch
Push Button Start Positions The system operates only when the driver is in the vehicle or within operational range while the key is being carried. Each time the push button start is pressed, the ignition switches in the order of off, ACC, and ON. Pressing the push button start again from ON sw ...

© 2016-2022 Copyright www.mcx5.org