Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear Bumper Disassembly/Assembly

Mazda CX-5 Service & Repair Manual / Body / Body Exterior, Frame / General / Rear Bumper Disassembly/Assembly

1. Disassemble in the order indicated in the table.



1

Screw

2

Reflector

3

Rear bumper face


2. Assemble in the reverse order of disassembly.

Rear Beltline Molding Removal/Installation
CAUTION: Affix protective tape to the position shown in the figure. 1. Fully open the rear door glass. 2. Insert a tape-wrapped flathead screwdriver and then detach the clip A in ...

Rear Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear splash shield. b. Rear combination light. c. Rear bumper. 3. Remove the hanger rubber in the direction of th ...

Other materials:

Rear Crossmember Removal/Installation [2 Wd]
WARNING: Verify that the rear crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-speed s ...

Keyless Antenna Removal/Installation
With Advanced Keyless Entry System Vehicle interior, front 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Decoration panel. b. Shift lever knob (MTX). c. Front console box. d. Shift panel. e. Upper panel. f. Rear console. g. Side wall. h. Front conso ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the output shaft (primary gear). The turbine/input shaft speed sensor and output shaft speed ...

© 2016-2022 Copyright www.mcx5.org