Mazda CX-5 Service & Repair Manual: Rear Brake (Disc) Removal/Installation

Mazda CX-5 Service & Repair Manual / Brakes / Disc Brakes / Rear Brake (Disc) Removal/Installation

1. Loosen the adjusting nut..

2. Remove in the order indicated in the table.

3. Install in the reverse order of removal.

4. After installation, add brake fluid, bleed the air, and inspect for fluid leakage..

5. Pump the brake pedal a few times and inspect the following:

The disc pad projection is securely installed to the piston groove
Parking brake lever stroke
Brake drag

1	Rear parking brake cable (See Rear Parking Brake Cable Installation Note.)
2	Bolt
3	Brake hose
4	Bolt
5	Caliper (See Caliper Installation Note.)
6	Disc pad
7	Shim
8	Guide plate
9	Bolt
10	Mounting support
11	Slide pin
12	Bushing
13	Dust boot
14	Disc plate

Caliper Installation Note

1. Clean the exposed area of the piston.

2. Rotate the piston clockwise slowly using the SST and push the piston completely until the piston grooves are in the position shown in the figure.

3. Install the caliper.

Rear Parking Brake Cable Installation Note

1. Install the rear parking brake cable to the rear caliper.

2. Verify that the outer end tabs of the rear parking brake cable is securely engaged with the bracket.

Rear Brake (Disc) Inspection

Brake Judder Repair Hints Description 1. Brake judder concern has the following 3 characteristics: Steering wheel vibration 1. The steering wheel vibrates in the rotation direction. This characte ...

Other materials:

Tiedown Hooks
CAUTION Do not use the front and rear tiedown eyelets for towing the vehicle. They have been designed only for securing the vehicle to a transport vessel during shipping. Using the eyelets for any other purpose could result in the vehicle being damaged. Tiedown Hooks 1. Remove the tiedown eye ...

Low And Reverse Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The low and reverse brake stops the rotation of the front internal gear and rear planetary carrier while in 1GR and in reverse, locking them to the transaxle case. Construction The low and reverse brake consist of the following parts shown in the figure. ...

Auto Dimming Mirror Inspection
1. Measure the voltage at each terminal. If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring harnesses. If the system does not work properly even though the inspection items or ...