CAUTION:
If configuration is not performed when the rear body control module (RBCM) is replaced with a new one, the vehicle specification information is not stored in the rear body control module (RBCM) and the system will not operate normally.
When performing configuration, it is necessary to read the vehicle specification information from the rear body control module (RBCM) before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the rear body control module (RBCM). The vehicle specification information is temporarily stored in the M-MDS.
NOTE:
The rear body control module (RBCM) prior to replacement stores the vehicle specification information.
A new rear body control module (RBCM) does not store any vehicle specification information.
If the vehicle specification information from the rear body control module (RBCM) prior to replacement cannot be read, perform the configuration using As-Built data.
1. When replacing the rear body control module (RBCM), perform the configuration..
2. Disconnect the negative battery cable..
3. Remove the following parts:
Trunk board.
Trunk end trim.
Rear scuff plate (LH).
Trunk side trim (LH).
4. Disconnect the connectors shown in the figure.
5. While pressing the rear body control module (RBCM) tab in the direction of arrow (1) shown in the figure, pull it in the direction of arrow (2) to detach the tab from the body.
6. Pull the rear body control module (RBCM) up in the direction of the arrow to detach the hook from the body.
7. Remove the rear body control module (RBCM).
8. Insert a tape-wrapped flathead screwdriver into the position shown in the figure.
9. Move the screwdriver in the direction of arrow (3) shown in the figure and pull the connector in the direction of arrow (4) to detach its tab from the rear body control module (RBCM).
10. Pull the connector in the direction of arrow (4) shown in the figure and remove it.
11. Install in the reverse order of removal.
NOTE:
If configuration cannot be performed by reading/writing of the vehicle specification information, perform the configuration using As-Built information after replacing the rear body control module (RBCM)..
Power Seat Switch Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
1. Switch the ignition off (LOCK).
2. ...
AWD
All-Wheel Drive (AWD) Operation
• AWD provides excellent drivability
on snow-covered and ice-packed roads, sand and mud, as well as on steep slopes and
other slippery surfaces.
• A system malfunction or operation conditions
are indicated by a warning.
Refer to Warning/Indicator Light ...
Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the ignition coil/ion sensors..
4. Remove the cylinder head cover..
5. Remove in ...