Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Rear ABS Wheel Speed Sensor Removal/Installation

1. Remove the trunk board..

2. Remove the trunk end trim..

3. Remove the rear scuff plate..

4. Remove the trunk side trim..

5. Disconnect the rear ABS wheel-speed sensor connector.


6. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicle.

7. Remove in the order indicated in the table.

8. Install in the reverse order of removal.

9. After installation, verify that there is no twisting in the rear ABS wheel-speed sensor.



1

Bolt

2

Rear ABS wheel-speed sensor

(See Rear ABS Wheel-speed Sensor Removal Note.)


Rear ABS Wheel-speed Sensor Removal Note

1. Pull aside the mudguard and remove the rear ABS wheel-speed sensor.

Rear ABS Wheel Speed Sensor Inspection [Awd]
Installation Visual Inspection 1. Inspect the following items: If there is any malfunction, replace the applicable part. a. Excessive play of the ABS wheel-speed sensor b. Deformation ...

Steering Angle Sensor
Purpose, Function The steering angle sensor outputs the steering angle and steering angle reference point during the period which the EPS control module performs initial learning (approx. ...

Other materials:

Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and suspend it out of the way using a cable. 2. Remove the disc plate. 3. Remove the wheel hub bolt using the SST as shown in the figure. 4. Place a new wheel hub bolt in the wheel hub. 5. Install the wheel hub by placing a proper sized washer o ...

Interior Care
WARNING Do not spray water in the cabin: Splashing water on electrical parts such as the audio unit and switches is dangerous as it could cause a malfunction or a fire. Dashboard Precautions Prevent caustic solutions such as perfume and cosmetic oils from contacting the dashboard. They will ...

Ion Sensor Inspection
DTC Inspection 1. Connect the M-MDS to the DLC?2. 2. Perform the DTC inspection using the M-MDS.. If any DTC related to the ignition coil/ion sensor is present, repair the malfunctioning location according to the applicable DTC troubleshooting.. Visual Inspection NOTE: B ...

© 2016-2026 Copyright www.mcx5.org